Running the wheel loader

Drive the 18.5 t wheel loader with its two pedals, back up without a gear lever, fill the bucket from a pile, feed the wash plant's hopper the right amount, and start the plant from the cab.

Level
◆ Beginner
Reading time
3 min read
Steps
6 steps
Updated
Updated Nov 21, 2026
Running the wheel loader: what this guide shows

You'll need: The 18.5 t wheel loader (every new site has one at the camp).

The wheel loader is an 18.5 t articulated machine with a 3.5 m³ heaped bucket: it bends in the middle to steer, and a torque converter and a four-speed powershift box drive all four wheels. It feeds the trommel's hopper and loads trucks from a stockpile.

Step 1: Drive with two pedals

There's no gear lever to worry about. RT (W) is the throttle and drives the way the machine is facing in gear; LT (S) is the brake. The left stick (A / D) steers by bending the machine in the middle, which you can do standing still.

The box changes gear by itself as you speed up. Drive hard into a pile and it drops to first by itself for the extra push.

Step 2: Back up

To reverse, stop and keep holding the brake for a moment. The machine changes over to reverse, and from then on the pedals swap: LT now drives you backwards and RT brakes. To go forward again, stop and hold RT: it changes back.

Step 3: Work the arms and bucket

The right stick is the loader lever:

  • Forward / back (I / K): arms up and down.
  • Right (L): rack the bucket back (curl it up to hold the load).
  • Left (J): dump the bucket.

The engine speeds up by itself when you move the lever, so the arms don't crawl at idle. If you want the full hydraulic speed while standing still, hold RB (N) for neutral and press the throttle: the engine revs for the pumps without driving the machine. Let go of RB and it goes back into the gear it was in.

Step 4: Fill the bucket from a pile

  1. Lower the arms until the bucket sits flat on the ground, with the bucket level.
  2. Drive straight into the pile at a steady speed.
  3. As the bucket goes in, raise the arms a little and rack the bucket back, so it peels the material up instead of pushing the pile along.
  4. Once it's full, rack it all the way back and back out.

Turn on the diff lock with B (X) on soft or muddy ground, where one wheel would otherwise spin. The bottom line shows Diff lock: ON while it's on.

Step 5: Feed the wash plant

Drive up to the trommel's grizzly (the bars over the hopper), raise the arms high enough to clear them, and dump the bucket over the bars.

You can start and stop the plant without leaving the cab: press X (P). The bottom line lists it as Wash plant start / stop.

![Feeding the wash plant from a pile](#SCREENSHOT NEEDED: the loader dumping a bucket over the trommel's grizzly, hopper about half full)

Step 6: Load a truck

Have the truck parked side-on to you on flat ground. Fill the bucket, back out, raise the arms high while you drive in, and dump over the middle of the body. Lower the arms as you back away.

The loader dumping into the dump truck
The loader dumping into the dump truck

The loader display

Hold View (or press F1) for the loader display: the gear (F, N or R and the number) and speed, how far the machine is bent, the push at the wheels, the arm and bucket angles with their cylinder pressures, and how full the bucket is (in m³ and as a share of its struck capacity).

Is what you're looking for not here?

Tell us what you'd like explained and we'll write a guide for it. You'll need to sign in first.

Request a guide: sign in

Request a guide

The more you tell us about where you got stuck, the better the guide.